Engine builder needed

[Craigar]

I just picked up a extended cab s10 and it has a spun rod bearing I wanted to know if anyone knew any decent engine builders. It's a 4.3 v6 just going to be a daily driver wouldn't mind having a little spunk but...

What price range would I be looking at

 

[Andrew_bram]

Get ahold of off the deep end he maybe able to help you out

 

[FinsUp]

Also talk to rings343. He's a mechanic.

 

[Dapozer]

http://www.colorado-custom-cylinder-heads.com/
I used these guys when I rebuilt the Hemi in the dodge. great shop and tons on knowledge. I would go there again. Not sure if they can do a complete (normal) rebuild but could get you in the right direction.

 

[Craigar]

Thanks guys I'm excited for this project

 

[Haulin Oates]

Dude... LS1

 

[Mav]

Gunn auto in Lakewood/ Denver did me right. Had an issue on my 4.0 that was my fault. They had my block machined, head rebuilt, rods pressed on, cam bearings installed, acid washed, line bored, crank turned. Was a few hundred bucks and turnaround was like 2 or 3 days


Sent from my iPad using Tapatalk