How much is too much?

Irishman

Tang
M.A.S.C Club Member
#1
My permanent QT tank is finally cycled so I am going to starting the TTM soon. I have around 12 fish that need to go through it, ideally I would want to do all the fish at once but that's definitely not happening sine I am using two 10 gallon tanks. I have prime on hand for ammonia control as well. What are some ideas about a magic number for me to go with to get these fish done? My original was going to be six but like I said I want to keep the ammonia under control, so I came here to get some insight.
 

Walter White

Reef Shark
M.A.S.C Club Member
#2
Just curoius why you need for the QT to be cycled? If you are doing TTM you just need some fresh water made up, a sponge filter preferable using a sponge seeded from your main display, and a heater.

There shouldn't be anything to cycle per say. not too mention the fish should only be in the tank between 48-72 hours before being transferred to another fresh tank anyway. I have done this many times just using biospira, no other cycle or even seeded sponges. In terms of the number of fish im not sure. You might want to ask that in the Cypto thread on RC. I have only ever done one fish at a time. I suppose you could do multiples but it seems to me like you would need to extend the TTM beyond 12 days. I'd go three weeks or a total of 7 transfers just to be safe.
 

Irishman

Tang
M.A.S.C Club Member
#3
To start off my 60 gallon got ick. I have a 40 gallon breeder tank that I eventually was going to get set up anyways. And since my 60 gallon has to fishless for 72 days I am using that as a temporary holding for the fish. That way I have a little bit more control over ammonia and everything else.
 

Walter White

Reef Shark
M.A.S.C Club Member
#4
Ok Just to be sure I understand. Its the 40 breeder you have cycled but you will be using the 10 gal tanks for TTM and then once thats complete you will move them to the 40 breeder until your 60g is done with the fallow period?
 

Irishman

Tang
M.A.S.C Club Member
#5
Correct
 

Fourthwind

Anthias
M.A.S.C Club Member
#7
The prime only bonds up the ammonia for up to 24 hours. If there is nothing to get rid of it IE bacteria or water changes, then it will un bind. Do not rely on it. Water changes and perhaps a filter with some stability
 

szavoda

Butterfly Fish
M.A.S.C Club Member
#8
I wouldn't do more than a couple of fish at a time. The ammonia levels can spike pretty quick. I have about the same problem - main tank has Velvet, I think. Total fish loss is at 6 out of 10 so far. at least 1 - 2 were from ammonia while I was out of town. And that was 10 smallish fish in a 55g.

Shawn
 

Irishman

Tang
M.A.S.C Club Member
#9
I think I'm going to do three at a time, that should allow me enough time to do what I need to do without the ammonia spiking to high.

szavoda;n635758 said:
I wouldn't do more than a couple of fish at a time. The ammonia levels can spike pretty quick. I have about the same problem - main tank has Velvet, I think. Total fish loss is at 6 out of 10 so far. at least 1 - 2 were from ammonia while I was out of town. And that was 10 smallish fish in a 55g.

Shawn
I remember your post on it, these fish will be getting in fresh water within a three day period so I should be fine.
 
Top