Sometime over night something happened in my system that caused the return section of my sump to go low enough for the pump not to push enough water back up into the tank.
(no water was going over the baffle from the sump to the return section). When I noticed this I turned the pump and skimmer off and a small amount of water drained back into the return section. I'm assuming that is from the return pipes going back up to the tank.
I also noticed that the overflow area is completely empty (normally just drains down to the two drain pipe levels (a Herbie system). The bottom of my stand had about 2 gallons of water in it and there is some water in the crawlspace below my tank. The floor around and under my tank is completely dry however. There was some evidence of water on top of the doors to my stand, but only a couple of drops.
Any thoughts on what could cause my overflow area and return section to empty, but nothing else in my system?
This is not how my tank looks now, this is from the initial setup 8 months ago. Just trying to give some reference to what my system looks like.
(no water was going over the baffle from the sump to the return section). When I noticed this I turned the pump and skimmer off and a small amount of water drained back into the return section. I'm assuming that is from the return pipes going back up to the tank.
I also noticed that the overflow area is completely empty (normally just drains down to the two drain pipe levels (a Herbie system). The bottom of my stand had about 2 gallons of water in it and there is some water in the crawlspace below my tank. The floor around and under my tank is completely dry however. There was some evidence of water on top of the doors to my stand, but only a couple of drops.
Any thoughts on what could cause my overflow area and return section to empty, but nothing else in my system?
This is not how my tank looks now, this is from the initial setup 8 months ago. Just trying to give some reference to what my system looks like.


