Inland band saw

CRW Reef

Blue Whale
M.A.S.C Club Member
ex-officio
#4
Ok ill just take it, thanks Allyson and Colin :)

No for real is this a dbtc, trade opportunity or are you selling?
 
Last edited by a moderator:

jahmic

Reef Shark
M.A.S.C Club Member
#11
Have you guys pulled it apart yet? Is it noisy like a vibration...or does it just sound louder than normal.

Not 100% familiar with that particular bandsaw, but it's possible the exposure to SW might warrant just checking the belts and pulleys to make sure they are still moving smoothly. Of course...that depends on whether it actually runs on belts and pulleys :p

Whether you decide to fix or sell...easiest thing to do is to remove the belts (or just the blade if that drives off the motor) and see if it still makes noise. If it does...then it's likely the motor bearings...if it shuts up, then you may just need to lube the pulleys, check the shafts to make sure they are still straight, and/or replace the belts. :)
 
Last edited by a moderator:

fishguy69

Dolphin
M.A.S.C Club Member
#15
Just needs a good cleaning, adjustment and possible replacement blade. Ours still howls to the moon but does the job well, LOL.
 
Top