So I am trying to wire a square pin ballast to straight pin lights. The ballast has two blue cords and two red, while the lights have a red, a green, a blue, and a black. Here's a pic. Any ideas?
from what I've read red is positive, black is negative, green is ground and white is neutral. I can't find any info on the two red and blue wires from the ballast though
Ok, from what I've found no matter if you have a square pin or straight pin setup you do 2 red on one side and blue on tge other. So if you were looking at the pins on the bulb pins 1 and 2 would be red and pins 3and 4 should be blue. Then you would use tge plug I gave you and go white to white, black to black, and green would ground on the ballast box itself.